Inscrição na biblioteca: Guest
Início Arquivos Representantes Futuras reuniões American Society of Thermal and Fluids Engineering
First Thermal and Fluids Engineering Summer Conference

ISSN: 2379-1748


Juliana M. Said
University of Pittsburgh, Pittsburgh, VA 15213, USA

Nick Jean-Louis
University of Pittsburgh, Pittsburgh, VA 15213, USA

Ashwin P. Iyer
University of Pittsburgh, Pittsburgh, VA 15213, USA

Jon Bates
University of Pittsburgh, Pittsburgh, VA 15213, USA

Mark L. Kimber
Texas A&M University, College Station, TX 77840, USA AI Engineering Building 205D, Texas A&M University, College Station, TX 77840, USA

DOI: 10.1615/TFESC1.hte.012963
pages 1335-1340

Palavras-chave: Piezoelectric fans, vibrating cantilevers, energy efficient convection enhancement


Piezoelectric fans are a potential low power thermal management solution for handheld and low profile electronic devices. Their design is simple and adaptable, enables noiseless operation, and makes use of resonance conditions which allow for a highly energy efficient cooling device. It has been shown that piezoelectric fans oscillating at their resonance frequency have the capability to significantly increase heat transfer over natural convection, but many of the fundamental studies have focused on an impingement orientation, one where the fan is positioned normal to the heated surface. This requires a significant amount of space to implement, and hence precludes many low profile applications, where volume usage must be as efficient as possible. In this study, the full field heat transfer coefficients maps are experimentally found for a piezoelectric fan oscillating parallel to the heated surface using infrared thermography. The effect of the distance between the fan blade and heater is explored by considering three different values for gap: 1 mm, 3 mm, and 5 mm. For these experiments, the oscillation amplitude is held constant at 10 mm. Results show that these small changes in gap can have a large impact on the heat transfer coefficient distributions. A gap of 1 mm yields the largest impact zone for thermal enhancement over natural convection, and produces wing-like contours. For the largest gap considered (5 mm), the impact zone become more localized near the fan tip and provides peak heat transfer performance higher than the 1 mm gap. At the intermediate gap, the contours are qualitatively similar to the 5 mm gap results, but with an improvement in heat transfer coefficient. Optimal performance is dependent on the intended target size of the heat source. The full field convection coefficient maps are analyzed in detail to produce optimization approaches for the design engineer. This includes gap and placement of the vibrating fan with respect to the heated target.

Compra $20.00 Check subscription Ética e negligência em publicaçãoes Recomendado ao My Librarian Inserir indicador nessa página